IMIS | Lifewatch regional portal

You are here

IMIS

[ report an error in this record ]basket (0): add | show Print this page

Measurements of air pollution emission factors for marine transportation in SECA
Alfoldy, B.; Loov, J.B.; Lagler, F.; Mellqvist, J.; Berg, N.; Beecken, J.; Weststrate, H.; Duyzer, J.; Bencs, L.; Horemans, B.; Cavalli, F.; Putaud, J.P.; Janssens-Maenhout, G.; Csordas, A.P.; Van Grieken, R.; Borowiak, A.; Hjorth, J. (2013). Measurements of air pollution emission factors for marine transportation in SECA. AMT 6(7): 1777-1791. dx.doi.org/10.5194/amt-6-1777-2013
In: Atmospheric Measurement Techniques. Copernicus Publications: Oldendorf. ISSN 1867-1381; e-ISSN 1867-8548, more
Peer reviewed article  

Available in  Authors 

Keyword
    Marine/Coastal

Authors  Top 
  • Alfoldy, B.
  • Loov, J.B.
  • Lagler, F.
  • Mellqvist, J.
  • Berg, N.
  • Beecken, J.
  • Weststrate, H.
  • Duyzer, J.
  • Bencs, L., more
  • Horemans, B., more
  • Cavalli, F.
  • Putaud, J.P.
  • Janssens-Maenhout, G., more
  • Csordas, A.P.
  • Van Grieken, R., more
  • Borowiak, A.
  • Hjorth, J.

Abstract
    The chemical composition of the plumes of seagoing ships was measured during a two week long measurement campaign in the port of Rotterdam, Hoek van Holland The Netherlands, in September 2009. Altogether, 497 ships were monitored and a statistical evaluation of emission factors (g kg-1 fuel) was provided. The concerned main atmospheric components were SO2, NO2, NOx and the aerosol particle number. In addition, the elemental and water-soluble ionic composition of the emitted particulate matter was determined. Emission factors were expressed as a function of ship type, power and crankshaft rotational speed. The average SO2 emission factor was found to be roughly half of what is allowed in sulphur emission control areas (16 vs. 30 g kg-1 fuel), and exceedances of this limit were rarely registered. A significant linear relationship was observed between the SO2 and particle number emission factors. The intercept of the regression line, 4.8 × 1015 (kg fuel)-1, gives the average number of particles formed during the burning of 1 kg zero sulphur content fuel, while the slope, 2 × 1018, provides the average number of particles formed with 1 kg sulphur burnt with the fuel. Water-soluble ionic composition analysis of the aerosol samples from the plumes showed that ~144 g of particulate sulphate was emitted from 1 kg sulphur burnt with the fuel. The mass median diameter of sulphate particles estimated from the measurements was ~42 nm.

All data in the Integrated Marine Information System (IMIS) is subject to the VLIZ privacy policy Top | Authors