| one publication added to basket [311701] | Full load estimation of an offshore wind turbine based on SCADA and accelerometer data
Noppe, N.; Iliopoulos, A.; Weijtjens, W.; Devriendt, C. (2016). Full load estimation of an offshore wind turbine based on SCADA and accelerometer data. Journal of Physics: Conference Series 753: 072025. https://dx.doi.org/10.1088/1742-6596/753/7/072025
In: Journal of Physics: Conference Series. IOP Publishing: Bristol. ISSN 1742-6588; e-ISSN 1742-6596, more
|   |
| Abstract |
As off shore wind farms (OWFs) grow older, the optimal use of the actual fatigue lifetime of an off shore wind turbine (OWT) and predominantly its foundation will get more important. In case of OWTs, both quasi-static wind/thrust loads and dynamic loads, as induced by turbulence, waves and the turbine's dynamics, contribute to its fatigue life progression. To estimate the remaining useful life of an OWT, the stresses acting on the fatigue critical locations within the structure should be monitored continuously. Unfortunately, in case of the most common monopile foundations these locations are often situated below sea-level and near the mud line and thus difficult or even impossible to access for existing OWTs. Actual strain measurements taken at accessible locations above the sea level show a correlation between thrust load and several SCADA parameters. Therefore a model is created to estimate the thrust load using SCADA data and strain measurements. Afterwards the thrust load acting on the OWT is estimated using the created model and SCADA data only. From this model the quasi static loads on the foundation can be estimated over the lifetime of the OWT. To estimate the contribution of the dynamic loads a modal decomposition and expansion based virtual sensing technique is applied. This method only uses acceleration measurements recorded at accessible locations on the tower. Superimposing both contributions leads to a so-called multi-band virtual sensing. The result is a method that allows to estimate the strain history at any location on the foundation and thus the full load, being a combination of both quasi-static and dynamic loads, acting on the entire structure. This approach is validated using data from an operating Belgian OWF. An initial good match between measured and predicted strains for a short period of time proofs the concept. |
|
